Check the pump pulley by removing the pump from the washer and trying to rotate it by hand. If the pulley doesn’t turn freely and is frozen or stiff, replace it. Also, if the agitator is moving but the tub isn’t, this is a sign the pump is dying.

What causes a washing machine drain pump to fail?

Defective Drain Pump When the control panel sends voltage to the drain pump, the drain cycle is supposed to begin. Water is then pumped from the washer tub out the drain hose and finally into a wash sink or drain pump. … Sometimes a damaged impeller or a defective seal can cause a mechanical failure in the pump.

How much is a washing machine pump?

Materials Needed. The most important part is a new washer pump. It can cost as little as $10 or as much as $75 or more. However, most homeowners pay between $25-$40 for a new pump.

How long does a water pump last on a washing machine?

Most low cost pressure washers are made with lower quality pumps. The life expectancy, of those pumps is around 60 to 100 hours of use. With higher quality pressure washers, the life expectancy of their pumps is closer to 500 hours. On average, households use their water pressure washer around 50 hours per year.

How much does it cost to replace a drain pump on a washing machine?

Washing Machine Pump Repair Cost If a pump is no longer working, it’s a relatively easy fix for a contractor and extends the lifetime of your appliance. On average, expect to spend $300 to $400 for a pump replacement job.

Is my washing machine pump broken?

Put your finger into the drain outlet and feel the impellers if the pump freely turns. One or more of them may be broken. If so, you’ll be able to feel them while you’re turning the pump flywheel with your other hand. You also may see broken pieces of plastic in the bottom of the pump housing.

Why is my washer not draining or spinning?

If your washer won’t drain or spin, the water level control may be faulty. Open the machine’s control panel and look for a plastic tube attached to the water level valve. If it’s clogged, clear it out with vinegar. If the valve itself is corroded, it may need to be replaced.

What are common problems with washing machines?

  • It Bounces Around. …
  • It’s Noisy. …
  • Clothes Are Getting Ripped. …
  • Improper Or Slow Draining. …
  • My Washing Machine Won’t Spin. …
  • There’s No Water. …
  • The Door Won’t Open. …
  • It’s Smelly.

Is it worth fixing a washing machine?

A relatively new washer may not break down regularly, hence it may be more affordable to repair it. Getting replacement parts for modern machines can be easier than finding components for older models. Washing machine repair is recommended when the repair cost is less than 50 percent of a new machine’s price.

Where is the pump located on a washing machine?

The pump is situated at the bottom of the washing machine and is used to pump the water from the wash, into the drain hose, to be drained away. If your washing machine is failing to drain during a wash cycle, it could be that there is a problem with the drain pump.

Article first time published on

How do you test a washing machine drain hose?

An easy way to check that the drain hose is clear is to blow air through it. If nothing is obstructing the drain tube, the problem is most likely at the washing machine pump. If the hose is worn or badly kinked, replacing the hose may improve the ability of the machine to pump water.

How do I know if my Whirlpool washer is clogged?

The drain pump is only accessible through disassembling your washer, but you can check for clogs by running a normal wash cycle to see if the water is draining. Twist the cycle knob to “Drain/Spin” and push “Start” to switch to the drain and spin cycle.

Where's the pump on a Whirlpool washing machine?

Locate the pump underneath the bottom of the washing machine. The pump is easy to locate because it has two hoses attached to it.

How do you know if your washer is clogged?

Observe the washing machine as it pumps water into the hoses and up into the standpipe. If you see water back up and out of the standpipe, your washer’s drain is most likely the issue. The amount of time it takes for the standpipe to fill up and overflow helps you diagnose where the clog is located.

Why is my water pump not pumping water?

Check the breaker or fuse box. Inspect your breaker box and see if the breaker has tripped, and if it has, then reset it and you should restore power to the pump. If the breaker trips again, then there is an electrical or mechanical issue with the water pump, which will require a professional plumber.

What to do if water pump is not working?

  1. Confirm that water into the building is turned on. …
  2. Confirm that the pump electrical power is on. …
  3. Check the water pressure gauge. …
  4. Check that the pressure control switch is not stuck. …
  5. If Present, Try the Pressure Control Switch Re-Set or Manual or Bypass Lever – if your pressure switch has one.

Why is my water motor not working?

A leak in your system will cause both of these issues. Replace any leaking or damaged pipes and check the water level to make sure that your pump hasn’t exceeded the well capacity. A faulty pressure switch will also cause the motor stay on or cycle too fast. Double-check the settings, and clean the contacts.

How do you clean a washing machine water pump?

  1. Open your washer’s filter access door. You’re looking for a small, rectangular door on the bottom right-hand corner of your machine. …
  2. Unhook the emergency drain hose. …
  3. Empty the hose. …
  4. Remove the drain pump filter. …
  5. Clean the drain pump filter. …
  6. Replace the drain pump.

Is a 20 year old washer worth fixing?

If your 20 year old washer isn’t rusted, and hasn’t been abused, it would have to depend on what repair is needed to get it working. If it’s a pump or even the motor, at a cost of $250 to repair, as long as you are pleased with it he way it cleans your clothes, I’d consider repairing it.

How do you know when to replace your washing machine?

  1. Excessive Leaking. A leaking washing machine is usually the most obvious sign that your washing machine has a problem. …
  2. Excessive Noise. …
  3. It Moves. …
  4. Water Doesn’t Fill the Drum. …
  5. Your Washer Is Older Than Eight Years Old. …
  6. You Have an Older Top Load Washer.